Mitsubishi Outlander: Automatic Transaxle
Mitsubishi Outlander 2007-2013 Service Manual / Automatic Transaxle and Propeller Shaft / Automatic
Transaxle
- General Information
- Automatic Transaxle Diagnosis (A/T)
- Diagnosis S-AWC (Super All Wheel Control)
- On-vehicle Service
- Transaxle Control
- Transaxle Assembly
READ NEXT:
General Information
F6AJA and W6AJA models have been established. For the AWD system mounted to
some vehicles,
based on the electronic control AWD which distributes
the driving force to the rear wheels, the driving
forc
Automatic Transaxle Diagnosis (A/T)
DIAGNOSTIC TROUBLESHOOTING FLOW
INTRODUCTION TO A/T DIAGNOSIS
When the A/T is failed, have an interview with the
user to gather precise information on the failure status.
After that, perform on-boa
DTC P0703, P0705, P0712, P0713, P0715, P0720, P0729, P0731, P0732,
P0733, P0734, P0735, P0736
DTC P0703: Stoplight Switch Malfunction
Stoplight switch system circuit
DESCRIPTIONS OF MONITOR METHODS
Drive the vehicle at 30 km/h (18.6 mph) or more
for 10 seconds, and then turn the ignition
SEE MORE:
Inspection Procedure 10-18
Inspection Procedure 10: The lock switch of the liftgate lock release
handle does not perform the
locking operation.
CAUTION
Before replacing the ECU, ensure that the power
supply circuit, the ground circuit and the communication
circuit are normal.
Liftgate Lock Release Handle Circuit
PROBABLE
Inspection Procedure 1-9
Inspection Procedure 1: Cannot communicate with KOS-ECU using the scan
tool.
CAUTION
Before replacing the ECU, ensure that the communication
circuit is normal.
TECHNICAL DESCRIPTION (COMMENT)
If the scan tool cannot communicate with the
KOS-ECU, the CAN bus lines may be defective. If
the KOS-ECU do
© 2010-2026 Copyright cw.mioutlander.com
