Mitsubishi Outlander: Door
- General Information
- Symptom Procedures (Central Door Locking System)
- Input Signal Procedures (Central Door Locking System)
- Power Window Diagnosis
- Symptom Procedures (Power Window)
- Door Diagnosis
- On-vehicle Service
- Door Assembly, Door Glass and Regulator, Door Handle and Latch
READ NEXT:
General Information
CENTRAL DOOR LOCKING SYSTEM
The central door locking system operates the door
lock actuator to lock or unlock the doors and liftgate
using the door lock switch built into the front power
window (main
Symptom Procedures (Central Door Locking System)
INSPECTION PROCEDURE A-1: Central Door Locking System does not Work at
All.
CAUTION
Before replacing the ECU, ensure that the power supply circuit, the ground
circuit and the communication
circuit a
Input Signal Procedures (Central Door Locking System)
INSPECTION PROCEDURE B-1: The Liftgate Lock Release Handle Signal is
not Received.
CAUTION
Before replacing the ECU, ensure that the power supply circuit, the ground
circuit and the communication
ci
SEE MORE:
Seat Assembly
FRONT SEAT ASSEMBLY
REMOVAL AND INSTALLATION
CAUTION
To remove the front seat assembly of vehicle with side air bag, refer to
GROUP 52B - Service Precautions and Curtain Air Bag Module.
Removal steps
Headrest
Front seat anchor cover
Rear seat anchor cover
Wiring harness connectors
Front
Hood
HOOD DIAGNOSIS
INTRODUCTION TO HOOD DIAGNOSIS
Wind noise at the hood may be caused by improper
hood adjustment.
HOOD DIAGNOSTIC TROUBLESHOOTING STRATEGY
Use these steps to plan your diagnostic strategy. If
you follow them carefully, you will be sure that you
have exhausted most of the possible ways
© 2010-2026 Copyright cw.mioutlander.com
