Mitsubishi Outlander: Engine oil
To check and refill engine oil
The engine oil used has a significant effect on the engine’s performance, service life and startability. Be sure to use oil of the recommended quality and appropriate viscosity.
All engines consume a certain amount of oil during normal operation. Therefore, it is important to check the oil level at regular intervals or before starting a long trip.
1. Park the car on a horizontal surface.
2. Switch off the engine.
3. Wait a few minutes.
4. Remove the dipstick and wipe it with a clean cloth.
5. Reinsert the dipstick as far as it goes.
6. Remove the dipstick and read the oil level, which should always be within the range indicated 7. If the oil level is below the specified limit, remove the cap located on the cylinder head cover and add enough oil to raise the level to within the specified range. Do not overfill to avoid engine damage. Be sure to use the specified engine oil and do not mix various types of oil.
8. After adding oil, close the cap securely.
9. Confirm the oil level by repeating step 4 to 6.
Use only the recommended oils with an ACEA or API classification as specified in this manual.
NOTE:
● Engine oil consumption is greatly influenced by payload, engine speed, etc. Depending on how you drive, it can reach 1.0 lit./1,000 km.
● The engine oil will deteriorate rapidly if the vehicle is subjected to severe conditions, requiring earlier oil replacement.
Please refer to the maintenance schedule.
● For information on how to dispose of used engine oil.
Recommended engine oil viscosity
Use engine oil conforming to the following classification:
• “VW 50501/50601”.
NOTE:
● Use of additives is not recommended since they may reduce the effectiveness of additives already included in the engine oil. It may result in failure of the mechanical assembly.
READ NEXT:
Engine coolant
To check the coolant level
A transparent coolant reserve tank (A) is located in the engine compartment.
The coolant level in this tank should be kept between the “LOW” and “FULL” marks
w
Washer fluid
Open the washer fluid reservoir cap and check the level of washer fluid with
the dipstick.
If the level is low, replenish the container with washer fluid.
NOTE:
● The washer fluid contain
Brake fluid/Clutch fluid
The brake fluid and the clutch fluid share reservoir tank.
To check the fluid level
The fluid level must be between the “MAX” and “MIN” marks on the reservoir.
The fluid level is monitore
SEE MORE:
Basic Brake
General Information
Brake systems with higher reliability and durability
have achieved distinguished braking performance.
FEATURES
IMPROVEMENT OF BRAKING PERFORMANCE
In addition to the 10-inch single brake booster,
the small and long stroke-type master cylinder is
used to achieve the downsizing
Braking
All the parts of the brake system are critical to safety. We recommend you to
have the vehicle checked at regular intervals according to the service booklet.
CAUTION:
● Avoid driving habits that cause heavy braking and never “ride” the brakes by
resting your foot on the brake pedal w
