Mitsubishi Outlander: Hazard warning flasher switch
Mitsubishi Outlander 2007-2013 Owner's Manual / Instruments and controls / Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency.
The hazard warning flashers can always be operated, regardless of the position of the ignition switch.
Push the switch to turn on the hazard warning flashers, all turn signal lamps flash continuously. To turn them off, push the switch again.
READ NEXT:
Fog lamp switch
Front fog lamp switch
The front fog lamps can be operated while the headlamps and tail lamps are on.
Turn the knob in the “ON” direction to turn on the front fog lamps. An indicator
lamp in
Wiper and washer switch
Windscreen wipers
The windscreen wipers can be operated with the ignition switch in the “ON” or
“ACC” position.
If the blades are frozen to the windscreen or rear window, do not operate th
Headlamp washer switch
The headlamp washer can be operated with the ignition switch in the “ON” or “ACC”
position and the lamp switch at the position.
Push the button once and the washer fluid will be sprayed o
SEE MORE:
DTC U1415, U0019, U0141, U0151, U0154, U0155, U0168, U0184, U0195
DTC U1415:Coding Not Completed
CAUTION
If DTC U1415 is set in the A/C-ECU, diagnose the
CAN main bus line.
CAUTION
Whenever the ECU is replaced, ensure that the
communication circuit is normal.
TROUBLE JUDGMENT
The A/C-ECU receives the vehicle information signals
from the ETACS-ECU via the CAN bus
Power Steering Hoses
REMOVAL AND INSTALLATION
Pre-removal operation
Power Steering Fluid Draining
Engine room Under Cover Front (A,B,C), Engine room
Side Cover, Engine room Under Cover Rear Removal
Propeller Shaft Assembly Removal
Front Exhaust Pipe Removal
Front Roll Stopper And Centermember Assembly Removal
© 2010-2026 Copyright cw.mioutlander.com
