Mitsubishi Outlander: Hazard warning flasher switch
Mitsubishi Outlander 2007-2013 Owner's Manual / Instruments and controls / Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency.
The hazard warning flashers can always be operated, regardless of the position of the ignition switch.
Push the switch to turn on the hazard warning flashers, all turn signal lamps flash continuously. To turn them off, push the switch again.
READ NEXT:
Fog lamp switch
Front fog lamp switch
The front fog lamps can be operated while the headlamps and tail lamps are on.
Turn the knob in the “ON” direction to turn on the front fog lamps. An indicator
lamp in
Wiper and washer switch
Windscreen wipers
The windscreen wipers can be operated with the ignition switch in the “ON” or
“ACC” position.
If the blades are frozen to the windscreen or rear window, do not operate th
Headlamp washer switch
The headlamp washer can be operated with the ignition switch in the “ON” or “ACC”
position and the lamp switch at the position.
Push the button once and the washer fluid will be sprayed o
SEE MORE:
Floor Console Assembly
FRONT FLOOR CONSOLE ASSEMBLY
REMOVAL AND INSTALLATION
Removal steps
Lower side cover
Front floor console bracket
Front floor console panel
Rear floor console assembly
Front floor console assembly
Interior transmission antenna
Front floor console base
Front floor console base bracke
LW/MW/FM digital tuning radio with CDchanger
The audio system can only be used when the ignition switch is in the “ON” or
“ACC” position.
NOTE:
● When listening to the audio system with the engine stopped, be sure to turn
the ignition switch to the “ACC” position.
● If a cellular phone is used inside the vehicle,
© 2010-2026 Copyright cw.mioutlander.com
