Mitsubishi Outlander: Headlight
- General Information, Diagnosis
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- On-vehicle Service
READ NEXT:
General Information, Diagnosis
General Information
As for headlight assembly, a type with halogen
bulbs for the high-beam and low-beam and a type
with a discharge bulb for both high-beam and
low-beam are established.
The hal
Diagnostic Trouble Code Procedures
DTC B16A2: Blown turn-signal light (LH) bulb
Turn-Signal Light Circuit (LH)
TROUBLE JUDGMENT
When the left bulb of turn-signal light is blown, the
ETACS-ECU sets DTC B16A2.
TECHNICAL DESCRIPTION (
Symptom Procedures
Inspection Procedure 1: None of headlights (low-beam) illuminates.
CAUTION
Whenever the ECU is replaced, ensure that the
power supply circuit, the ground circuit and the
communication circuit are norm
SEE MORE:
DTC B2204, B2206, B2352, B2416, C1608, C1910, C1920, C1930, C1940, C1911,
C1921, C1931, C1941, C1912, C1922, C1932, C1942, C1913, C1923, C1933, C1943,
C1914, C1924, C1934, C1944
DTC B2204: Coding data mismatch
CAUTION
When DTC B2204 is set, be sure to diagnose
the CAN bus line.
When replacing the ECU, always check that
the communication circuit is normal.
DTC SET CONDITION
If the vehicle information data transmitted from the
ETACS-ECU via the CAN bus lines is differen
Cruise control
Cruise control is an automatic speed control system that lets you keep the same
driving speed. It can be activated at 40 km/h (25 mph) or more.
CAUTION:
● When you do not wish to drive at a constant speed, deactivate the cruise control
function for safety.
● Do not use cruise cont
© 2010-2026 Copyright cw.mioutlander.com
