Mitsubishi Outlander: Inspection and maintenance followingrough road operation
After operating the vehicle in rough road conditions, be sure to perform the following inspection and maintenance procedures:
● Check that the vehicle has not been damaged by rocks, gravel, etc.
● Carefully wash the vehicle with water.
Drive the vehicle slowly while lightly depressing the brake pedal in order to dry out the brakes. If the brakes still do not function properly, we recommend you to have the brakes checked as soon as possible.
● Remove the insects, dried grass, etc. clogging the radiator core.
● After driving through water, check the engine, transmission and differential oil. If the oil or grease is milky or cloudy because of water contamination, it must be replaced with new oil.
● Check the inside of the vehicle. If water entry is found, dry the carpet etc.
● Inspect the headlamps, If the headlamp bulb is flooded with water, we recommend you to have it drained.
READ NEXT:
Cautions on the handling of 4-wheel drivevehicles
Tyres and wheels
Since the driving torque can be applied to the 4 wheels, the driving performance
of the vehicle when operating in 4-wheel drive is greatly affected by the condition
of the tyres.
Braking
All the parts of the brake system are critical to safety. We recommend you to
have the vehicle checked at regular intervals according to the service booklet.
CAUTION:
● Avoid driving habits
Anti-lock brake system (ABS)
Environmental conditions can have an effect on braking. During sudden braking
when there is snow, ice, oil, water etc. on the road surface, a skid may occur.
In this situation, steering control an
SEE MORE:
Balancer Timing Chain, Balancer Shaft and Oil Pump Module
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Timing Chain Removal and Installation
Removal steps
Timing chain tensioner
Balancer timing chain guide
Balancer timing chain guide
Balancer shaft and oil pump
module
Balancer timing chain
Crankshaft sprocket
Required S
Valve Stem Seal
REMOVAL AND INSTALLATION
CAUTION
*Remove and assemble the marked parts in each cylinder unit.
Pre-removal operation
Engine Room Under Cover Front B and Engine Room Side
Cover (RH) Removal
Engine Oil Draining
Rocker Cover Assembly Removal
Engine Oil Pan Removal
Timing Chain Removal
Post-in
