Mitsubishi Outlander: Making a flat seat
By removing the head restraints and fully reclining the seatbacks of the seats, one large flat seat is achieved.
WARNING:
● Never drive while there are occupants sitting on the flat seat. This can be extremely dangerous.
CAUTION:
● To make a flat seat, stop the vehicle in a safe place.
● Make sure the seat is adjusted by an adult or with adult supervision for correct and safe operation.
● When sliding the seat, be sure not to catch your hand or leg.
● Do not walk around on top of the seats after they have been laid flat.
● To ensure the seats are locked securely, attempt to move them back and forth.
● Do not jump on, or impact the seatbacks heavily.
● To raise the seatback, raise it slowly while supporting it with your hands. Never let a child perform this operation. Doing so could result in an accident.
1. Remove the head restraints from the front seats, raise the armrest and remove the cargo area cover (if so equipped) (refer to “Head restraints” and “Cargo area cover”).
2. Move the second seat fully to the rear (refer to “To adjust forward or backward”).
3. Slide the front seats fully forward, then recline the seatbacks backwards to achieve a flat surface (refer to “To adjust forward or backward” and “To recline the seatback”).
4. Recline the seatbacks of the second seat backwards (refer to “To recline the seatback”).
5. The flat seat configuration is now complete. To return the seats to the normal position, reverse the above procedure.
READ NEXT:
Seat belts
To protect you and your passengers in the event of an accident, it is most important
that the seat belts be worn correctly While drive.
The front seat belts have a pre-tensioner system. These belts
Pregnant women restraint
WARNING:
● Seat belts work for everyone, including pregnant women. Pregnant women should
use the available seat belts. This will reduce the likelihood of injury to both
the woman and the un
Seat belt pre-tensioner system and forcelimiter system
The driver’s seat and front passenger’s seat each have a seat belt equipped with
a pre-tensioner system.
Pre-tensioner system
The pre-tensioner system will retract their respective seat belts
SEE MORE:
Multi-information display
The following information is included on the multi-information display: warnings,
odometer/tripmeter, service reminders, engine coolant temperature, fuel remaining,
outside temperature, 4WD operation status, average and momentary fuel consumption,
driving range, average speed and meter illumin
How To Use Troubleshooting, Inspection Service Points
TROUBLESHOOTING CONTENTS
DANGER
The SRS-ECU adopts the rollover specification
that the curtain airbag and seat belt
pre-tensioner operate at the occurrence of
rollover. Therefore, do not tilt the vehicle to
the right and left with the IG ON or tilt the
SRS-ECU to the right and left with the IG ON
an
