Mitsubishi Outlander: Accessory socket
CAUTION:
● Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less.
When using more than one socket at the same time, make sure that the electrical accessories are 12 V accessories and that the total power consumption does not exceed 120 W.
● Long use of the electric appliance without running the engine may run down the battery.
● When the accessory socket is not in use, be sure to close the lid or install the cap, because the socket might become clogged by foreign material and be short-circuited.
To use a plug-in type accessory, open the lid or remove the cap, and insert the plug in the accessory socket.
NOTE:
● Accessory sockets in 3 locations can be used at the same time. However, make sure that the total power consumption does not exceed 120 W.
The accessory socket can be used while the ignition switch is in either the “ON” or “ACC” position.
READ NEXT:
Interior lamps
1- Luggage room lamp 2- Room lamp (rear).
3- Map & room lamps (front).
4- Foot lamps P. 8-58.
NOTE:
● If you leave the lamps on without running the engine, you will run down the
batt
Storage spaces
CAUTION:
● Never leave lighters, canned carbonated beverage, and spectacles in the cabin
when parking the vehicle in hot sunshine. The cabin will become extremely hot, so
lighters and other
Cup holder
CAUTION:
● Do not drink beverages while driving. This is distracting and could cause an
accident.
For the driver’s seat
There is a built-in cup holder in the instrument panel on the dri
SEE MORE:
Post-collision Diagnosis
To inspect and service the SRS after a collision (whether or not
the air bags have deployed), perform the following steps.
SRS-ECU MEMORY CHECK
Required Special Tool:
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
MB991824:Vehicle Communication Interface (V.C.I.)
MB991827:M.U.T.-III USB Cable
Inspection Procedure 10-18
Inspection Procedure 10: The lock switch of the liftgate lock release
handle does not perform the
locking operation.
CAUTION
Before replacing the ECU, ensure that the power
supply circuit, the ground circuit and the communication
circuit are normal.
Liftgate Lock Release Handle Circuit
PROBABLE
