Mitsubishi Outlander: Diagnostic Trouble Code Procedures
Mitsubishi Outlander 2007-2013 Service Manual / Engine / Multiport Fuel Injection (MFI) - 2.4L Engine / Diagnostic Trouble Code Procedures
- DTC P0010, P0011, P0013, P0014, P0016, P0017, P0031, P0032, P0037, P0038
- DTC P0053, P0068, P0069, P0101, P0102, P0103, P0106, P0107, P0108
- DTC P0111, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0125, P0128, P0130, P0131
READ NEXT:
DTC P0010, P0011, P0013, P0014, P0016, P0017, P0031, P0032, P0037, P0038
DTC P0010: Intake Engine Oil Control Valve Circuit
CIRCUIT OPERATION
The intake engine oil control valve power is supplied
from the MFI relay (terminal No. 2).
The ECM controls ground intake en
DTC P0053, P0068, P0069, P0101, P0102, P0103, P0106, P0107, P0108
DTC P0053: Linear Air-Fuel Ratio Sensor Heater Resistance
LINEAR AIR-FUEL RATIO SENSOR HEATER CIRCUIT
CIRCUIT OPERATION
Power is supplied from the MFI relay (terminal
No. 2) to the linear air-fu
DTC P0111, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0125, P0128,
P0130, P0131
DTC P0111: Intake Air Temperature Circuit Range/Performance Problem
INTAKE AIR TEMPERATURE SENSOR CIRCUIT
CIRCUIT OPERATION
Approximately 5 volts are applied to the intake air
temperature sensor
SEE MORE:
Balancer Timing Chain, Balancer Shaft and Oil Pump Module
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Timing Chain Removal and Installation
Removal steps
Timing chain tensioner
Balancer timing chain guide
Balancer timing chain guide
Balancer shaft and oil pump
module
Balancer timing chain
Crankshaft sprocket
Required S
Fusible links
The fusible links will melt to prevent a fire if a large current attempts to
flow through certain electrical systems.
In case of a melted fuse link, we recommend you to have your vehicle inspected.
For the fusible links, please refer to “Fuse load capacity”.
WARNING:
● Fusible links
© 2010-2026 Copyright cw.mioutlander.com
