Mitsubishi Outlander: Engine Mechanical - 2.4L Engine
Mitsubishi Outlander 2007-2013 Service Manual / Engine / Engine Mechanical - 2.4L Engine
General Information
The 4B12 (2.4 L) engine is an in-line four-cylinder engine. The cylinder numbers are assigned as 1-2-3-4 from the front of the engine (timing belt side).
The firing order is 1-3-4-2.
Engine Diagnosis
Service Specifications
Sealants and Adhesive
Special Tools
- On-vehicle Service
- Crankshaft Pulley
- Camshaft
- Valve Stem Seal
- Oil Pan
- Crankshaft Oil Seal
- Cylinder Head Gasket
- Timing Chain
- Balancer Timing Chain, Balancer Shaft and Oil Pump Module
- Balancer Shaft and Oil Pump Module
- Engine Assembly
READ NEXT:
On-vehicle Service
DRIVE BELT TENSION CHECK
1. Remove the radiator condenser tank mounting bolt, and
move the radiator condenser tank to a place where it does
not interfere with the drive belt tension check.
CAUTION
Ch
Crankshaft Pulley
REMOVAL AND INSTALLATION
Pre-removal operation
Engine Room Under Cover Front B and Engine Room
Side Cover (RH) Removal.
Post-installation operation
Drive Belt Tension Check.
Engine Room Under C
Camshaft
REMOVAL AND INSTALLATION
Pre-removal Operation
Engine Room Under Cover Front A, B and Engine Room
Side Cover (RH) Removal.
Air Cleaner Assembly Removal.
Strut Tower Bar Removal.
Post-installatio
SEE MORE:
Fuel consumption
NOTE:
● The results given do not express or imply any guarantee of the fuel consumption
of the particular vehicle.
The vehicle itself has not been tested and there are inevitably differences between
individual vehicles of the same model. In addition, this vehicle may incorporate
part
Electronically controlled 4WD system
The electronically controlled 4WD system is an 4-wheel drive system that allows
one of three drive modes to be selected with a switch, in accordance with the driving
conditions.
The following drive modes are available.
4-wheel drive operation requires special driving skills.
Carefully read
© 2010-2026 Copyright cw.mioutlander.com
