Mitsubishi Outlander: Exterior
- Specification(s), Front/Rear Bumper Assembly
- Radiator Grille, Moldings, Garnishes
- Door Sash Tape
- Side Air Dam, Under Cover, Roof Rail, Liftgate Spoiler
- Windshield Wiper and Washer
- On-vehicle Service
- Windshield Wiper, Windshield Washer
- Rear Wiper and Washer
- Rear Wiper and Washer
- Outside Mirror
READ NEXT:
Specification(s), Front/Rear Bumper Assembly
Specification(s)
SERVICE SPECIVFICATIONS
ADHESIVES
LUBRICANT
Front Bumper Assembly
REMOVAL AND INSTALLATION
Pre-removal and post-installation operation
Headlight support panel cover removal and i
Radiator Grille, Moldings, Garnishes
Radiator Grille
REMOVAL AND INSTALLATION
Removal steps
Headlight support panel cover
Front bumper assembly
Radiator grille
Front-three diamond mark
Headlight support upper panel
cover
Mol
Door Sash Tape
SPECIAL TOOL
REMOVAL AND INSTALLATION
Pre-removal and post-installation operation
Door Trim Assembly Removal and Installation
Door Beltline Weatherstrip Inner Removal and Installation
Door Openin
SEE MORE:
Indicator lamps
Turn-signal indicator lamps/Hazard
warning indicator lamps
These indicator lamps blink on and off when a turn-signal lamp is operating.
NOTE:
● If the blinking is too fast, the cause may be a blown lamp bulb or a faulty
turn-signal connection.
When the hazard warning lamp switch is pre
Diagnosis
CAN BUS DIAGNOSTICS TABLE
CAUTION
A diagnostic trouble code may not also be set in
the CAN-B lines under the conditions below. If no
diagnostic trouble code has been set due to electrical
noise, confirm diagnostic item 26.
Open circuit at the CAN_H side of the CAN-B
bus lines
Open circuit at the
© 2010-2026 Copyright cw.mioutlander.com
