Mitsubishi Outlander: Windshield Wiper and Washer
Mitsubishi Outlander 2007-2013 Service Manual / Body, Exterior, Interior and Supplemental / Exterior / Windshield Wiper and Washer
- General Information
- Symptom Procedures (Inspection Procedure 1-6)
- Symptom Procedures (Inspection Procedure 7-12)
READ NEXT:
General Information
WINDSHIELD WIPER AND WASHER OPERATION
Intermittent control (Vehicle speed-dependent
variable type) <Initial condition: with function>
1. ETACS calculates the windshield intermittent wiper inter
Symptom Procedures (Inspection Procedure 1-6)
INSPECTION PROCEDURE 1: The windshield wipers do not work at all.
Windshield Wiper Power Supply Circuit
CIRCUIT OPERATION
The windshield wiper and washer switch sends a
signal through the column-
Symptom Procedures (Inspection Procedure 7-12)
INSPECTION PROCEDURE 7: The rain sensitive AUTO wiper function does not
work at all <Vehicles
with lighting control sensor>.
CAUTION
Whenever ECU is replaced, ensure that the input and output s
SEE MORE:
Diagnostic Trouble Code Procedures
DTC 15: Cruise Control Switch System
Cruise Control Switch Circuit
CIRCUIT OPERATION
This circuit judges the signals of each switch
("ON/OFF", "CANCEL", "COAST/SET" and
"ACC/RES") of the cruise control switch. The ECM
detects the state of the cruise control switch by sensing
the voltages shown bel
Inspection Procedure
INSPECTION PROCEDURE 1: Communication between scan tool and AWC-ECU
cannot be
established
CAUTION
If there is any problem in the CAN bus lines,
an incorrect trouble symptom may occur.
Prior to this diagnosis, always diagnose the
CAN bus lines.
Whenever the ECU is replaced, ensure that
the CA
© 2010-2026 Copyright cw.mioutlander.com
