Mitsubishi Outlander manuals

Mitsubishi Outlander: Tools and jack

Mitsubishi Outlander 2007-2013 Owner's Manual / For emergencies / Tools and jack

Storage

The tools and jack are stowed on the right side of the luggage area.

The storage location of the tools and jack should be remembered in case of an emergency.

1- Jack.

1- Jack.

2- Tools.

Tools

1- Tool case.

1- Tool case.

2- Wheel nut wrench.

3- Jack bar.

4- Towing hook.

Jack

To remove

1. Turn the knob (A) anticlockwise and remove the lid (B).

1. Turn the knob (A) anticlockwise and remove the lid (B).

2. Remove the fastening band (C) and remove the tools.

2. Remove the fastening band (C) and remove the tools.

3. Retract the jack and remove it from its installation fitting (D).

3. Retract the jack and remove it from its installation fitting (D).

To store

1. Retract the jack, then return it to its original position.

2. Extend the jack and firmly secure it.

3. Return the tools to the tool bag, return it to its original position, and

3. Return the tools to the tool bag, return it to its original position, and firmly fasten with the fastening band.

4. Install the lid and turn the knob clockwise.

READ NEXT:

 How to change a tyre

Before changing a tyre, first stop your vehicle in a safe, flat location. 1. Park the vehicle on level and stable ground, free of loose pebbles, etc.. 2. Set the parking brake firmly. 3. Turn the i

 Towing

If your vehicle needs to be towed If you need to tow your vehicle, we recommend that you contact a MITSUBISHI MOTORS Authorised Service Point or tow truck company. In the following cases, transp

 Operation under adverse driving conditions

On a flooded road ● Avoid flooded roads. Water could enter the brake discs, resulting in temporarily ineffective brakes. In such cases, lightly depress the brake pedal to see if the brakes

SEE MORE:

 DTC B1731, B1761, B1A08, B1A09, B1A0A, B1A0B, B1A10, B1A11, B1A12, B1A13, B1A24, B1A25, B1A28, B1A35, B2101, B2102, B2204, B2206

DTC B1731: Engine Control Module communication timeout CAUTION When the DTC B1731 is set, be sure to diagnose the CAN bus line. When replacing the ECU, always check that the communication circuit is normal. DTC SET CONDITION KOS-ECU checks that the Engine Control Module data has been received

 Differential

DISASSEMBLY AND ASSEMBLY Disassembly Steps Final gear Differential side bearing (transmission case side) Differential side bearing (converter housing side) Differential sub-assembly Required special tools: MB990801: Real axle bearing puller MB990811: Side bearing puller cap MB990956: Ne

© 2010-2026 Copyright cw.mioutlander.com