Mitsubishi Outlander: Turn-signal lever
1- Turn-signals.
When making a normal turn, use position (1). The lever will return automatically when cornering is completed.
2- Lane-change signals.
When moving the lever to (2) slightly to change a lane, the side turn-signal lamps and indicator lamp in the instrument cluster will only flash while the lever is operated.
Also, when you move the lever to (2) slightly then release it, the side turn-signal lamps and indicator lamp in the instrument cluster will flash three times.
NOTE:
● If the lamp flashes unusually quickly, the bulb in a turnsignal lamp may have burned out. We recommend you to have the vehicle inspected.
● It is possible to activate the following functions. For further information, we recommend you to consult a MITSUBISHI MOTORS Authorised Service Point.
On vehicles equipped with Mitsubishi Multi-Communication System (MMCS), screen operations can be used to make the adjustment. Refer to the separate owner’s manual for details.
• Flashing of the turn-signal lamps when the lever is operated with the ignition switch in the “ACC” position
• Deactivate the turn-signal lamp 3-flash function for lane changes
● You can adjust the time required to operate the lever for the 3-flash function.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorised Service Point.
READ NEXT:
Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the
road for any emergency.
The hazard warning flashers can always be operated, regardless of the position
of the igni
Fog lamp switch
Front fog lamp switch
The front fog lamps can be operated while the headlamps and tail lamps are on.
Turn the knob in the “ON” direction to turn on the front fog lamps. An indicator
lamp in
Wiper and washer switch
Windscreen wipers
The windscreen wipers can be operated with the ignition switch in the “ON” or
“ACC” position.
If the blades are frozen to the windscreen or rear window, do not operate th
SEE MORE:
On-vehicle Service
DOOR FIT ADJUSTMENT
Required Special Tools:
MB990211: Slide Hammer
MB990243: Body Puller
MB990900 or MB991164: Door Adjusting Wrench
MB990939: Brass Bar
CAUTION
Do not rotate special tool MB991164 with a torque of
over 98 N*m (72 ft-lb).
1. When the clearance between the door and the body
Engine Control
GENERAL INFORMATION
For the accelerator system, the electronic throttle
valve control system, disposing of the accelerator
cable, is adopted.
This system determines the amount of pressure
applied to the accelerator pedal using the built-in
accelerator pedal position sensor of the accelerator
pedal
