Mitsubishi Outlander: Wiper deicer switch
Mitsubishi Outlander 2007-2013 Owner's Manual / Instruments and controls / Wiper deicer switch
The rear window demister switch can be operated when the engine is running.
When the front wipers have frozen to the windscreen at the parked positions, turning on this switch will heat the windscreen to make the wipers operable. Press the switch and the deicer will operate and turn on the indicator lamp (A).
NOTE:
● The switch is automatically turned off after operating for approximately 20 minutes. To turn off the switch while it is operating, press the switch again.
READ NEXT:
Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister. It will be turned off automatically
in about 20 minutes. To turn o
Horn switch
Press the steering wheel on or around the
mark
SEE MORE:
DTC P0010, P0011, P0013, P0014, P0016, P0017, P0031, P0032, P0037, P0038
DTC P0010: Intake Engine Oil Control Valve Circuit
CIRCUIT OPERATION
The intake engine oil control valve power is supplied
from the MFI relay (terminal No. 2).
The ECM controls ground intake engine oil control
valve by turning the power transistor in the
ECM "ON" and "OFF".
TECHNICAL DESCR
DTC B1731, B1761, B1A08, B1A09, B1A0A, B1A0B, B1A0C, B1A0D, B1A0E, B1A0F,
B1A10, B1A11, B1A12, B1A13, B1A14, B1A15, B1A16, B1A17, B1A24, B1A25, B1A28,
B1A35, B2101, B2102
DTC B1731: Engine control module communication timeout
CAUTION
When the DTC B1731 is set, be sure to diagnose
the CAN bus line.
When replacing the ECU, always check that
the communication circuit is normal.
DTC SET CONDITION
WCM checks that the engine control module data
has been received via
© 2010-2026 Copyright cw.mioutlander.com
