Mitsubishi Outlander: Suspension and Axle
Mitsubishi Outlander 2007-2013 Service Manual / Suspension and Axle
- Front Suspension
- Rear Suspension
- Rear Suspension Diagnosis
- Control Link, Upper Arm and Lower Arm
- Trailing Arm Assembly
- Shock Absorber Assembly
- Stabilizer Bar
- Front Axle
READ NEXT:
Front Suspension
General Information
The MacPherson strut type suspension is adopted.
CONSTRUCTION DIAGRAM
Fastener Tightening Specifications
General Specifications
COIL SPRING
NOTE: * : Heavyduty suspension for F
Rear Suspension
General Information
A trailing arm type multi-link suspension is used. The
main features are listed as follows:
The wheel tread is enlarged to improve cornering
ability.
The roll center height is
Rear Suspension Diagnosis
INTRODUCTION TO REAR SUSPENSION DIAGNOSIS
If the rear suspension is faulty, the vehicle will not run
straightforward or noise will occur. Incorrect wheel
alignment, malfunction of shock absorber, stab
SEE MORE:
On-vehicle Service
WHEEL SPEED SENSOR OUTPUT CURRENT
MEASUREMENT
Required Special Tools:
MB991709: Wiring harness set
The relevant wheel, on which the wheel speed sensor is fitted,
should be free to run.
1. Remove the wheel speed sensor connector to be checked.
CAUTION
For precise measurement, do not connect to th
Diagnostic Item 1-5
DIAGNOSTIC ITEM 1: Diagnose when the scan tool cannot receive the data
sent by ETACS-ECU
CAUTION
When servicing a CAN bus line, ground yourself by touching a metal object such
as an unpainted
water pipe. If you fail to do so, a component connected to the CAN bus line may
be damaged.
CAN Communica
© 2010-2026 Copyright cw.mioutlander.com
